How to fill gaps without Green Stuff and Shadow Spectres WIP

Here is some progress on my Shadow Spectres.  Still needs some work all over.  Especially on the armor, bases and guns. Pretty much all over.

This is a little trick I came up with for glueing resin and plastic.  I originally needed something to hold some larger magnets in place, and have since used it for all types of uses.  From filling gaps, to making resin bonds stronger.  If you have every glued resin, you know that unless you have two surfaces that have a lot of surface area on the join, the bond won't be very strong.  Also, green stuff is great to form and shape into very detailed textures, but isn't super sticky and is not very supportive for the structure you are building.

This technique is super simple and inexpensive.  I wasn't pleased with my Wraith Seer stance, so I broke him apart and started over.  I glue the joint (here the hip joint) and then put some extra super glue in the space I need to fill.  Then I take a small wad of toilet paper and push it into the area with a knife or mould line remover.  Here you can see the size of the piece and the joint with the super glue/toilet paper already in the join.  

And some more toilet paper pushed into the gluey joint.  Sometimes you have to add extra glue to soak all the toilet paper, or cut extra TP from the joint.  Also, be careful if you have a large amount of area to fill, or if you don't pack the TP very tightly.  It has happened to me a few times, where the super glue saturates the TP, dries super quickly and gives off a lot of heat.  It puts out a lot of heat.  So much that I have had it smoke as the super glue dries.   This TP needs a bit more super glue.

 Here I did the same thing with the knee.  The great thing about this filler, is that it sets up like cement, is super strong, holds the two resin parts together and you can cut the excess with a sharp knife.  It paints fine, and is very resilient.  I have put green stuff over it before to get a super smooth surface.  I put a double ply, flat piece of TP between the resin base and the foot of the model.  It made a super strong bond.  I usually pin resin bases, but with the TP/super glue concoction, I don't need to pin it.

 Here's the final pose.  I wasn't completely satisfied, so he's in parts again.